|
Points Credit : 150 points Currently valued at $3.00 The CoolIT Eliminator is recommended for CPUs with a total heat output of up to 125W. The CoolIT Eliminator is targeted for overclocking nearly any dual core CPU while the CoolIT Freezone is more than capable of cooling the new quad core kentsfield from Intel.
MTEC Chilling Technology
Improves CPU Performance
Reduces Noise
Simple Installation
Fits Inside Chassis
Maintenance-Free Operation
Enhances PC Reliability
Universal Compatibility
The TCM on the CoolIT Eliminator has 3 settings - low, medium and high. "Low" is intended for very low power CPU's in a multimedia setting where there is a desire for very low noise output. "Medium" will be more than adequate cooling for day to day activities as well as gaming for stock processor speeds. "High" is maximum cooling power for the overclocking enthusiasts.
Eliminator has 3 TECs with a total maximum power draw of 40W.
The Eliminator CPU Cooler requires less maintenance than air or water-cooling systems. The liquid system itself is factory-sealed and a closed loop constructed with vapor resistant materials and fitted with gas resistant plumbing. This way, the Eliminator CPU Cooler never requires refilling, for the entire life of the system. The chiller module itself has a heatsink that promotes laminar air-flow through the fins. Laminar flow ensures that dust, dirt and particulates simply pass through the fin array, while promoting maximum thermal transfer. The only maintenance the Eliminator CPU Cooler system requires is the occasional dusting of the exhaust fan. This can be accomplished in a few seconds using compressed air, or gas.
The Eliminator is also a closed loop, factory sealed pre-filled system to offer maintenance free running for over 50,000 hours. The Eliminator will also include universal compatibility to fit Socket 478, 775, Core 2, 939 and AM2.
CPU FHE - (Fluid Heat Exchanger)
Design: Monolithic copper, multi-cell, single channel
Dimension: 42 x 42 x 17 mm
Weight: 195 grams
TCM- (Thermal Control Module)
Design: Dual IC SMT PCB w/outboard IC sensor
Input: 12VDC, 5VDC
Weight: 89 x 53 mm
Function: Thermal controller to adjust TEC and fan power output.
CHILLER & PUMP MODULE- (Heatsink)
Design: 3-way dissipation plate, anodized alloy, laminar flow array.
Dimension: 105 mm (diameter) x 60 mm (deep)
Weight: 380 grams
(TECs)
Design: Three solid-state heat pump wafers
Dimension: 40 x 40 x 3.5 mm (each)
Weight: 20 grams (each) x 3
Function: Active coolant thermal reduction
(Chiller FHE's):
Design: Tri anodized alloy distribution, multi-channel w/laminar flow.
Dimension: 41 x 41 x 12 mm (each)
Weight: 32 grams (each) x 3 (Fan)
Noise: 34dBA
Bearing Type: Enhanced life ceramic
Life Cycle: 50,000 hrs
Dimension: 92 x 92 x 38 mm
Function: Heatsink convection, chassis exhaust (Pump and Reservoir)
Design: 12VDC coreless outrunner pump w/integrated expansion vessel.
Bearings: Dual in fluid sapphire bearings
Noise: <15dBA
Life Cycle: 50,000 hours
Dimension: 50 x 50 x 75 mm
Weight: 360 grams
Warranty:
1 Year Warranty
| 
